Switching Between The Headset And Phone - RocketFish RF-QX3 User Manual

Switching between the headset and phone

• While a call is in progress, double-press the power/send/end button or
use the switching function on the phone.
Erasing all pairing information
To erase all pairing information:
Turn off the headset.
1
At the same time, press and hold the power/send/end and volume up
2
buttons until the indicator flashes. After erasing all pairing information,
the headset enters pairing mode automatically.
Turning the indicator on or off
You can turn the indicator on or off when the headset is connected to
a phone or during a call.
To turn the indicator on or off:
• At the same time, press the power/send/end button and the volume up
button for about four seconds. The indicator turns off. Repeat this step to
turn the indicator back on.
Checking the battery status
When the headset is paired and connected to a phone, press and
hold the power/send/end button for about two seconds.
• If the indicator flashes once yellow-green, the battery level is over half of
battery capacity.
• If the indicator flashes once yellow-green and red, the battery level is less
than half, but has more than one hour of talk time.
• If the indicator flashes once red, the battery level has less than one hour
talk time.
Resetting the headset
To reset the headset:
• Connect the charger. The headset is turned off and reset.
Note: You should only use the reset function when the headset operates unusually.
When you reset the headset, pairing information is not erased.
10
RF-QX3 Wireless Bluetooth Headset