ATEN CS1708i User Manual page 51

Setting
RESTORE This function is used to undo all changes and return the setup to
DEFAULT the original factory default settings (see Restoring Factory Default
VALUES Settings, page 193).
CLEAR THE This function clears all the port names, and does not affect any
NAME LIST other settings.
ACTIVATE Choices are Y (On), or N (Off). When activated, the beeper sounds
BEEPER whenever a port is changed; when activating the Auto Scan
function (see F7: SCAN, page 38); or an invalid entry is made on
an OSD menu. The default is Y.
SET QUICK This function lets the administrator select which ports to include as
VIEW PORTS quick view ports.




The default has no ports selected for Quick View.
RESET STATION If you change the position of one of the Stations in the daisy chain,
IDS the OSD settings will no longer correspond to the new situation.
This function directs the OSD to rescan the Station positions of the
entire installation and updates the OSD so that the OSD Station
information corresponds to the new physical layout.
Note: Only the Station Numbers get updated. Except for the Port
Names, all Administrator settings (such as Set Accessible Ports,
Set Quick View Ports, etc.), for all of the computers affected by the
change, have to be manually redone.
SET Specifies the operating platform of the computer attached to each
OPERATING port. For each port, press [Space] to cycle through the choices
SYSTEM (Win, Mac1, Sun, and Mac2). Repeat until all the ports have been
set, then press [Esc]. The default is Win.
Note: If you are installing a Sun or Mac computer, before you run it
for the first time you must set the correct operating system for the
port it is connected to with this function; otherwise, it will not boot.
FIRMWARE In order to upgrade the CS1708i / CS1716i firmware (see
UPGRADE page 142), you must first enable Firmware Upgrade mode with this
setting.
When you bring up this menu, the current firmware version levels
are displayed. Select Y to enable Firmware Upgrade mode, or N to
leave this menu without enabling it.
To select/deselect a port as a Quick View Port, double-click the
port, or use the navigation keys to move the highlight bar to it,
then press [Spacebar].
When a port has been selected as a Quick View Port, an icon
displays in the QV column of the port list on the Main Screen.
When a port is deselected, the icon disappears.
If one of the Quick View options is chosen for the LIST view (see
F2: LIST, page 31), only a port that has been selected here will
display on the list.
If one of the quick view options is chosen for Auto Scanning (see
SCAN–SKIP MODE, page 33), only a port that has been
selected here will be Auto Scanned.
Function
4. OSD Operation
35