ATEN CS1708i User Manual page 144

CS1708i / CS1716i User Manual
 Adding Filters
To add an IP filter, do the following:
1. Click Add. A script prompt dialog box appears.
2. Specify whether you are filtering an IPv4 or IPv6 address.
3. Key the address you want to filter in the From: field.
 To filter a single IP address, click to put a check in the Single IP
checkbox.
 To filter a continuous range of addresses, key in the end number of
the range in the To: field.
Note: This description is for the AP GUI. The Browser GUI differs as
follows:
1. It doesn't offer an IPv4 or IPv6 choice. It only has From and
To fields for IPv4 filtering.
2. It doesn't have a checkbox to specify a single IP address. To
filter a single IPv4 address, key the same address in both the
From and To fields.
4. After filling in the address, click OK.
5. Repeat these steps for any additional IP addresses you want to filter.
128