Table of Contents
Advertisement
Software Control
6. Start the ADS42JBxxEVM software
•
On Windows platforms, start the ADS42JBxx EVM GUI software from Start → All Programs →
Texas Instruments ADCs → ADS42JBxx.
7. Go to "Low Level View" and click the "Load Config" button.
ADS42JB69_EVM_LMF421_250M.cfg. This configuration file should be located in the GUI software
installation directory.
•
The configuration file sets the ADC up for Fsampling = 250 MHz, lane rate = 2.5 GHz, L = 4, M =
2, F = 1.
6
ADS42JB46, ADS42JB49, and ADS42JB69 Evaluation Module
Figure 3. ADS42JBxx EVM GUI Setup
(Figure
3).
Copyright © 2012–2017, Texas Instruments Incorporated
Copyright © 2017, Texas Instruments Incorporated
SLAU467D – November 2012 – Revised February 2017
Submit Documentation Feedback
www.ti.com
Advertisement
Table of Contents
