ActionTec MWTV3TX User Manual page 14

LINK LED blinks fast in orange (pairing). When this occurs, remove the USB flash drive
from the device.
Note: If firmware update fails, the LINK LED will glow steady in red for about 10 seconds,
and then the device reboots.
Go to your MWTV3 transmitter (at the source end) and power off the device.
8.
Plug the USB flash drive into the USB port on the transmitter.
9.
10. Press and hold the RESET button with a pin, and then power on the device.
11. The firmware upgrade begins when the LINK LED blinks slowly in red. You can now
release the RESET button.
12. The device reboots to finish the upgrade. And firmware upgrade is complete when the
LINK LED blinks fast in orange (pairing) or glows steady in green (paired). When this
occurs, remove the USB flash drive from the device.
Note: If firmware update fails, the LINK LED will glow steady in red for about 10 seconds,
and then the device reboots.
Once the firmware update has been applied to all MyWirelessTV3 devices, the
MyWirelessTV3 devices will pair automatically, and stream audio and video.
After the transmitter and receiver are paired again, go to the receiver, and press the MENU
button to display system information. You can check if the devices are updated to the desired
firmware on the system information screen.
12