First Data FD-400 Installation Manual

Portable terminal

Hide thumbs Also See for FD-400:

Download this manual

Enlarged version

Warning:

A shielded-type power cord is required in order to meet FCC emission

limits and also to prevent interference to the nearby radio and television

ORTABLE

ERMINAL

reception. It is essential that only the supplied power cord be used.

Use only shielded signal cables to connect I/O devices to this

equipment.

FD-400

You are cautioned that changes or modifications not expressly

approved by the party responsible for compliance could void your

authority to operate the equipment."

NSTALLATION

UIDE

First Data Corporation

c/o Tasq Technology

800-835-3362 Ext. 0

http://www.firstdata.com/

Printed in the United States of America.

Page 1 NSTALLATION UIDE First Data Corporation c/o Tasq Technology 800-835-3362 Ext. 0 http://www.firstdata.com/ Printed in the United States of America. © Copyright 2006 First Data Corporation. All rights reserved. © 2007 First Data Corporation.
Page 2 3. U SING THE EADER 1. P OWER ON ERMINAL Find the reader slot in the middle of surface. Swipe There are two holes under a plastic cover on the Figure 1 card through slot in left to right or the opposite right side of terminal (Figure 1).
Page 3 Federal Communications Commission Notice FCC Radiation Exposure Statement This device complies with part 15 of the FCC Rules. Operation is subject to the foll This equipment complies with FCC radiation exposure limits set forth for an owing two conditions: uncontrolled environment . End users must follow the specific operating (1) This device may not cause harmful interference, and instructions for satisfying RF exposure compliance.