Outfeed Zone Hazard; Kickback - RIDGID SP6263 Owner's Manual

Outfeed Zone Hazard

DANGER
Rotational force of blade can pull
hands and fingers back into blade.
Touching, holding, or pulling on out-
feed side of workpiece while blade is
still spinning will result in fingers,
hand or arm being cut off. To reduce
risk of outfeed hazard:
S et pawls and riving knife; they act as par-
[
tial barrier to outfeed side.
S tart and finish cut from infeed side.
[
K eep both hands on infeed side.
[
K eep hands away from outfeed side.
[
P ush workpiece through to complete cut.
[
Do not reach around to pull it.
I f blade jams, turn saw off, remove yellow
[
key, then free blade.

Kickback

Kickback is the uncontrolled propelling of the
workpiece back toward the user.
WARNING
Kickback can happen when blade is
pinched or bound
Pinching or binding can happen when:
• pawls and riving knife are not used or not
set correctly
• riving knife is not aligned with blade
• blade is not parallel to fence
• workpiece is twisted or warped and rocks
on table top
• pressure is put on outfeed side of work-
piece
• workpiece is released before being
pushed past pawls
• user touches or tries to pull workpiece
through outfeed side before blade has
stopped spinning.
by workpiece.
Ripping
51