Repetitive Crosscutting; Crosscutting Hints - RIDGID SP6263 Owner's Manual

Crosscutting

Repetitive Crosscutting

Repetitive crosscutting is the repeated and
continuous cutting of many pieces of lumber
to the same length. Carriage and length
stops can help make this type of crosscutting
more efficient.
A carriage stop defines the distance needed
to pull the blade through to complete each
cut. This will prevent pulling the blade
through more than the recommended dis-
tance.
To make a carriage stop use 1x2 lumber:
a) cut two pieces, each 2" long
b) clamp a piece on each side of radial arm,
so blade carriage stops at distance needed
to complete cut
c) check that clamps do not interfere with
hand grip on saw handle.
A length stop defines the cut length and
ensures that all pieces will be cut to the
same size. Clamp a piece of 1x2 lumber on
the fence to define the cut length.
Keep hand holding down workpiece at
least 8" from blade.

Crosscutting Hints

1. To extend life of table top, make auxil-
iary table cover out of 1/4" plywood or
fiberboard. Clamp or nail to original table
top, section by section. If you use nails,
nail in the four corners to make sure blade
will not contact nails.
2. Make several fences, so each will have
only a few kerfs (See Cutting Aides). Too
many kerfs will weaken a fence.
3. Keep table clean of chips and sawdust.
4. Use sharp blades, and use the right
blade for each job.
5. When making miter or bevel cuts, use
extra force to hold workpiece down
48
Carriage
Stop
because it tends to move during these
types of cuts.
6. Do not miter on the left side of the table
in a manner that allows the blade to come
off of the table.
7. When cutting hard woods, like oak, or
making compound cuts, keep arm holding
saw handle rigid and pull blade through
slowly.
8. To keep cut line accurate, periodically
check blade alignment.
9. Do not cut severely warped, bowed or
twisted workpieces.
Length
Stop