Make Front Table Flat - RIDGID SP6263 Owner's Manual

Adjustments
5. Drop a flat washer into each counter-
bored hole.
1/4-20 x 1"
17/64"
1/4-20 x 1-3/4"
Pan Head Screw
Flat Washer
6. 1-3/4"
Start long pan head screw through
Pan Head Screw
center hole and into U-clip, but do not fully
tighten.
Front Table
7. Start cup point set screw through leveling
hole and into tee nut, but do not fully tighten.
8. Put 1" long pan head screw in each of
Lockwasher
four remaining holes and through matching
holes in table supports. Place lockwasher
and nut on the end of each screw, and Hex Nut
1/4-20 x 1"
tighten with screwdriver.
Cup Point Set Screw
Rear Table

Make Front Table Flat

Board
Hold Down Leveling
1. Place rear table on its edge, across cen-
Screw
Set Screw
ter of front table. Check for gap between sur-
faces.
If there is a gap, close gap by raising or low-
ering center of front table:
to raise center, tighten cup point set screw
against frame;
Front Table
to lower center, tighten center (1-3/4" long)
pan head screw.
2. When gap is closed, make sure cup point
set screw touches frame (look underneath
table), and center (1-3/4" long) pan head
screw is tightened.
This concludes adjusting your saw where you have removed all "looseness" or slack between the
different parts of the saw. The next section deals with actually aligning the sawblade to get accu-
rate cuts.
27