Identification Codes - Kenwood TK-7360 Instruction Manual

n Transmitting
1 Select your desred zone and channel.
2 Press the key programmed as Selcall or Selcall + Status.
3 Press /
or <B/C> to select the ID of the staton you want to call.
• You can also enter the staton ID drectly by usng the keypad.
4 Press the PTT swtch and begn your conversaton.
• You can also press
n Receiving
If enabled by your dealer, an alert tone wll sound and the LED wll blnk when
a Selcall has been receved. To respond to the call, press the PTT swtch and
speak nto the mcrophone.
n Identification Codes
An ID code s a combnaton of a 3-dgt Fleet number and a 4-dgt ID number.
Each transcever must have ts own Fleet and ID number.
Note: The ID range may be lmted by programmng.
P C
AGING ALL
1 Select your desred zone and channel.
2 Press the key programmed as Paging Call to transmt your PTT Lst ID, to
request a call.
S M
TATUS ESSAGE
Status messages are 2-dgt codes rangng from 10 to 99 (80 ~ 99 are reserved
for specal messages).
A maxmum of 15 receved messages can be stored n the stack memory of your
transcever and can be revewed after recepton. The
message s stored n the stack memory.
n Transmitting
If programmed by your dealer, you can press the Call 1 ~ Call 3 keys to
quckly send preprogrammed status messages. You can also manually send
status messages.
1 Select your desred zone and channel.
2 Press the key programmed as Status or Selcall + Status.
• When pressng the Status key, the target Fleet/ ID is fixed and cannot be
selected. Skp to step 5 to contnue.
3 In Selcall mode, press / (if the key assignment list selection is configured
as "Enabled") or <B/C> to select the ID of the staton you want to call.
• You can also enter the staton ID drectly by usng the keypad.
12
(if the key assignment list selection is configured as "Enabled")
to page the ID, rather than talkng.
n
con appears when a