Hardware Interface Description
① Charging Slots (USB 2.0 Type A Plug)
Store, recharge and link microphones in the USB slots. Slots are
associated to channels in an APT according to the system setup in the
GUI.
② Power LED
Illuminates when the unit powered on.
③ Link LED
Illuminates after a successful link.
④ Link Button
Press and hold for 10 seconds to link all microphones in the charger to
channels of the associated APT.
⑤ Battery Status LEDs
Monitor microphone battery status during a charge, in increments of 10,
25, 50, 75, 100%
⑥ Locking DC Power Supply Jack
Screw the PS45 power supply to the input, illuminating the POWER LED.
⑦ Power Switch
Powers the unit on or off
⑧ Ethernet Port
Connects to the MXW system using a Cat5e (or higher) cable.
⑨ Network Status LED (Green)
• Off = no network link.
• On = sending or receiving digital audio over the network.
• Flashing = cannot establish a connection.
20
Networked Charger (NCS)
①
②
③
④
⑩ Network Speed LED (Amber)
• Off = 10 Mbps
• On = 100 Mbps
⑤
Charger Slots Correspond to Audio Channels
1
2
3
4
5
6
7
8
8-Channel Charger (NCS8)
⑩
⑨
⑥
⑧
⑦
1
2
3
4
4-Channel Charger (NCS4)