Service And Adjustments - Ariens 911513 Owner's And Operator's Manual

WARNING: AVOID INJURY. Read
and understand Maintenance and
Service and Adjustments safety rules
before proceeding.
SERVICE POSITION
Put unit into service position for easy access
to underneath the deck.
CAUTION: Avoid fuel spills. Follow
steps below to help prevent fuel
spills. If fuel leaks into air cleaner,
replace air cleaner. ALWAYS clean
up any spilled fuel.
1. Place unit on a flat, level surface.
2. Remove fuel cap, place a piece of plastic
bag over the opening and tighten cap
securely.
3. Adjust handlebar forward to service
position and secure (Figure 10).
4. Tip unit onto left side, opposite the
discharge opening.
Make sure unit is secure and will not tip
over.
IMPORTANT: Remove plastic from fuel cap
after unit is upright and service is complete.
Figure 10
HANDLEBAR HEIGHT
To adjust (Figure 11, 11a):
1. Place a hole at the bottom of the braces
over the pins on the bracket. On 911526,
use the fasteners to attach one of the
holes at the top and one of the holes at
the bottom.

SERVICE AND ADJUSTMENTS

OM0215
Pin
Hole
4
GB - 19
Figure 11
911526
4
2
1
4
1. Brace
2. Handlebar
3. Support Bracket
4. Fasteners
Figure 11a
OM0275
3
4
OM0271