Table of Contents
Advertisement
T
T
I
O
HE
NSTALLER
Carefully read all instructions for the installation prior to installing
unit. Make sure each step or procedure is understood and any spe-
cial considerations are taken into account before starting installa-
tion. Assemble all tools, hardware and supplies needed to com-
plete the installation. Some items may need to be purchased lo-
cally. After deciding where to install unit, closely look the location
over - both the inside and outside of home. Note any potential ob-
stacles or problems that might be encountered as noted in this
manual. Choose a more suitable location if necessary.
SHIPPING INSPECTION
Upon receiving the unit, inspect it for damage from shipment.
Claims for damage, either shipping or concealed, should be filed
immediately with the shipping company. Check the unit model
number, specifications, electrical characteristics and accessories
to determine if they are correct. In the event an incorrect unit is
shipped, it must be returned to the supplier and must NOT be
installed. The manufacturer assumes no responsibility for instal-
lation of incorrectly shipped units.
REPLACEMENT PARTS
O
P
RDERING
ARTS
When reporting shortages or damages, or ordering repair parts,
give the complete unit model and serial numbers as stamped on
the unit's nameplate.
Replacement parts for this appliance are available through your
contractor or local distributor. For the location of your nearest
distributor, consult the white business pages, the yellow page
section of the local telephone book or contact:
SERVICE PARTS DEPARTMENT
GOODMAN MANUFACTURING COMPANY, L.P.
5151 SAN FELIPE, SUITE 500
HOUSTON, TEXAS 77056
(713) 861 – 2500
SAFETY INSTRUCTIONS
The following symbols and labels are used throughout this manual
to indicate immediate or potential safety hazards. It is the owner's
and installer's responsibility to read and comply with all safety
information and instructions accompanying these symbols. Fail-
ure to heed safety information increases the risk of personal injury,
property damage, and/or product damage.
D
O NOT CONNECT TO OR USE ANY DEVICE THAT IS NOT DESIGN-CERTIFIED
G
BY
OODMAN FOR USE WITH THIS UNIT.
PERSONAL INJURY, REDUCED UNIT PERFORMANCE AND/
CONDITIONS MAY RESULT FROM THE USE OF SUCH NON-APPROVED DEVICES.
WARNING
S
ERIOUS PROPERTY DAMAGE,
OR
HAZARDOUS
HIGH VOLTAGE
!
D
ALL
ISCONNECT
POWER BEFORE SERVICING OR INSTALLING
M
THIS UNIT.
ULTIPLE POWER SOURCES MAY BE PRESENT. FAILURE
TO DO SO MAY CAUSE PROPERTY DAMAGE, PERSONAL INJURY OR
DEATH.
C
ONNECTING UNIT DUCT WORK TO UNAUTHORIZED HEAT PRODUCING DEVICES
SUCH AS A FIREPLACE INSERT, STOVE, ETC. MAY RESULT IN PROPERTY
DAMAGE, FIRE, CARBON MONOXIDE POISONING, EXPLOSION, PERSONAL
INJURY OR DEATH.
T
HIS PRODUCT CONTAINS OR PRODUCES A CHEMICAL OR CHEMICALS WHICH
MAY CAUSE SERIOUS ILLNESS OR DEATH AND WHICH ARE KNOWN TO THE
S
C
TATE OF
ALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS OR OTHER
REPRODUCTIVE HARM.
T
O AVOID PROPERTY DAMAGE, PERSONAL INJURY OR DEATH, DO NOT USE
THIS UNIT IF ANY PART HAS BEEN UNDER WATER.
QUALIFIED SERVICE TECHNICIAN TO INSPECT THE FURNACE AND TO REPLACE
ANY PART OF THE CONTROL SYSTEM AND ANY GAS CONTROL HAVING BEEN
UNDER WATER.
T
HIS UNIT MUST NOT BE USED AS A "CONSTRUCTION HEATER" DURING THE
FINISHING PHASES OF CONSTRUCTION ON A NEW STRUCTURE.
USE MAY RESULT IN PREMATURE FAILURE OF THE UNIT DUE TO EXTREMELY
LOW RETURN AIR TERMPERATURES AND EXPOSURE TO CORROSIVE OR VERY
DIRTY ATMOSPHERES.
T
O PREVENT THE RISK OF PROPERTY DAMAGE, PERSONAL INJURY, OR DEATH,
DO NOT STORE COMBUSTIBLE MATERIALS OR USE GASOLINE OR OTHER
FLAMMABLE LIQUIDS OR VAPORS IN THE VICINITY OF THIS APPLIANCE.
CODES AND REGULATIONS
The GPH M-series heat pumps are designed for OUTDOOR USE
ONLY. GPH M-Series is available in cooling capacities of 2, 2.5 3, 4
and 5 nominal tons of cooling. Optional field installed heat kits are
available in 5,8,10,15 and 20 kW. The units can be easily installed
in manufactured or modular homes with existing high-static duct
work. The units can also be easily converted to accommodate a
plenum for normal or low-static applications. The GPH M-series
are self contained packaged units so the only connections needed
for installation are the supply and return ducts, the line and low
voltage wiring and drain connection. The units are ETL listed and
AHRI certified.
The information on the rating plate is in compliance with the FTC &
DOE rating for single phase units.
3
WARNING
WARNING
WARNING
WARNING
I
MMEDIATELY CALL A
WARNING
T
HIS TYPE OF
WARNING
Hide quick links:
Advertisement
Table of Contents
