Adjusting Hand And Day Indicator Alignment; Alignment - Casio Oceanus OCW-G2000S-1A Operation Manual

Adjusting Hand and
Day Indicator

Alignment

Strong magnetism or impact can cause the
hands and/or the day indicator to go out of
alignment. If this happens, adjust hand and
day indicator alignment.
The watch performs alignment of the hour
●
hand, minute hand, second hand, and 24-
hour hand automatically.
Adjusting Hand and Day
Indicator Alignment
1.
Pull out the crown to the second click.
2.
Hold down (B) for about five seconds, until
the second hand moves to 12 o'clock.
This will start auto alignment of the hour
hand, minute hand, second hand, and 24-
hour hand.
After auto alignment is complete, the
●
hands should be in the positions shown
below.
24-hour hand
Minute hand Hour hand
Second hand
3.
Press (C).
Confirm that the small hour hand and
small minute hand are stopped at 12
o'clock.
Small hour hand Small minute hand
Operation Guide 5501
4.
If the small hour hand and small minute
hand are not at 12 o'clock, rotate the
crown to align them correctly.
5.
Press (C).
Confirm that the disk is positioned so
"UTC" is in the center.
6.
If "UTC" is not positioned in the center of
the disk, rotate the crown until it is.
7.
Press (C).
Confirm that the day of the week hand is
stopped at 12 o'clock, and check if the day
is indicated properly.
Day of the week hand
8.
If the day of the week hand and or the day
indicator is out of alignment, rotate the
crown to move the day of the week hand
to 12 o'clock and the day to the center of
the indicator window.
The movement range of the day of the
●
week hand and day indicator is limited
when you rotate the crown. The
maximum left-right movement of the
Crown
day of the week hand is 180 degrees in
either direction. The day indicator
moves only slightly.
After the day of the week hand and day
●
indicator are in the positions you want,
advance to step 11 of this procedure. If
you are unable to make the adjustments
you want, go to step 9.
Disk
Day (Operation start day)
9.
Press (C).
Confirm that the day indicator shows 1.
Day
Changing the date setting will cause the
●
day of the week hand to rotate
repeatedly. In some cases, the day of
the week hand may continue to rotate
for about 5 minutes.
Hand and Day Indicator Movement
l
10.
If 1 is not shown for the day, rotate the
crown until 1 is shown for the day.
The day of the week hand moves in
●
conjunction with crown rotation. Move
the day of the week hand to 12 o'clock.
11.
Push the crown back in.
Note
Leaving the crown pulled out for
●
more than approximately 30 minutes
without performing any operation
will automatically cause the
adjustment operation to become
disabled. If this happens, push the
crown back in to its normal position
and then pull it out again to restart
the procedure from the beginning.
Pushing the crown in to its normal
position part way through the
alignment procedure will cause the
hands to return to their normal
position. Any alignment you
performed up to that point will be
applied.
15