Operation Guide 5625 Before Getting Connecting with a Phone ● Alarm on/off setting H Started... Hold down (B) for at least 0.5 seconds until the In the Alarm Mode, the second hand second hand points to [C]. indicates if the alarm is enabled or This section provides an overview of the watch disabled.
Operation Guide 5625 Stopwatch Mode Alarm Mode Fast Forward/Fast Reverse ● ● ● The second hand, and the small hour and The small hour and minute hands indicate the Crown minute hands indicate the elapsed stopwatch alarm time. time. The second hand indicates the alarm enabled/ disabled setting.
Operation Guide 5625 Remaining Charge and Dead Battery Charging Time Guidelines Solar Charging ● ● You can determine if the charge level is low by The table below shows guidelines for This watch runs on power supplied from a checking the hand movement. Functions approximate charging times.
Level 1 to illuminate the display for about three power saving. seconds for viewing in the dark. When turned Your phone needs to have the CASIO ● on, illumination becomes gradually brighter “CASIO WATCHES” app installed to pair Also, leaving the watch in a dark location for and then gradually dimmer.
Operation Guide 5625 Appropriate Signal Reception Referring to the information below, configure Time Adjustment Using a the time setting in accordance with the method Location Time Signal that suits your own lifestyle. A time calibration signal can be received while the watch is near a window.
Operation Guide 5625 Time Calibration Signal Reception Auto Time Calibration Signal Manual Time Signal Receive Ranges Receive Important! An automatic time calibration signal receive Japan (JJY) ● operation is performed and the time and day The Japan time signal radio stations are A manual time calibration signal ●...
City (Time Zone) List If your watch is connected with a phone, ● Press (C). settings must be configured so CASIO This enables the year ten’s digit setting Tokyo (+9 offset) WATCHES can acquire location operation. information. Even if you are in an area that...
Operation Guide 5625 Configuring the Summer Time Setting ● Checking the Last Time Rotate the crown to move the second (Home City) Adjustment Result hand to the desired setting for the year The watch’s current time setting can be one’s digit. changed to summer time when required.
: Watch operation : Phone operation Note Press (B). The first time you start up CASIO ● Getting Ready The second hand will indicate the last WATCHES phone app, a message will receive result for nine or ten seconds.
1. Y Tap the “CASIO WATCHES” icon. If the watch does not indicate the ● Specifying a World Time City with CASIO correct time even if it is able to connect 2. Y Perform the operation shown on the with a phone, adjust the hand and day WATCHES causes the watch’s World Time...
After establishing a connection between the Configuring Timer Settings watch and a phone, you can use CASIO Important! WATCHES to configure watch settings and to Enter the Calendar Mode and then press ●...
Enter the Calendar Mode. phone screen to change your Home City Unpairing the watch from a phone requires Navigating Between Modes summer time setting. both CASIO WATCHES phone app and watch operations. 2. X Press (B). This will cause the second hand to...
Operation Guide 5625 Selecting a Time Zone Configuring the Summer 3. X Hold down (B) for at least 10 seconds. Time Setting (Dual Time) This deletes the pairing information. The Use the procedure below to specify the time second hand will point to [C]. zone where the city whose time you want to The watch’s current time setting can be use for Dual Time is located.
To specify a countdown start time of 24 ● hours, align the small hour and minute hands with 12 o’clock, so the small 24- hour hand aligns with 24. You can also use CASIO WATCHES ● to configure timer settings.
● The watch will beep when the alarm time is below. an alarm time is reached. reached. You can also use CASIO WATCHES ● Second hand The beeper is muted in the cases described ● to configure alarm time settings.
Operation Guide 5625 International Travel Note Press (C). When you enter another time zone, the watch Confirm that the mode hand is stopped at Leaving the crown pulled out for more will adjust its time setting to your current ● 12 o’clock, and check if the day is than approximately 30 minutes without location in accordance with the time zone of...
This section provides non-operational For information about phones that can Phone finder information you also need to know. Refer to connect with the watch, visit the CASIO Watch operation sounds the alert sound this information as required. website. of the phone.
Enable the watch’s Airplane Mode ● criminal offense. For details, visit the CASIO Using the Watch in a Medical Facility or Is the watch’s battery charged? Website. Aircraft Signal reception is not possible while https://world.casio.com/ce/BLE/...
Page 20
“Adjusting Hand and Day Indicator Alignment” to auto adjust Did you install the CASIO WATCHES hour and minute hand alignment. Is there an alarm configured to sound phone app on your phone?
Page 21
I can’t connect after turning off the them. phone. Deleting Pairing Information from the Turn on the phone and then tap the “CASIO CASIO WATCHES phone app WATCHES” icon. Next, on the watch, hold iPhone Only down (B) for at least 0.5 seconds until the Deleting the phone’s pairing...
Page 22
After 24 hours or more have passed since city to its network and then adjust the time setting. ● swapping using CASIO WATCHES or watch operation Time signal reception is not performed After 24 hours or more have passed since the ●...
Page 23
Push the crown back in to its normal position and then pull it out again to re-enable crown operations. Using the Crown Other I can’t find the information I need here. Visit the website below. https://world.casio.com/support/...