Husqvarna 390XP Workshop Manual page 47

5. Fit tool 4310048-67 as shown in fig. 4 and remove
the crankcase half on the clutch side.
6. Remove the crankcase half on the flywheel side in
the same way as item 4 above.
7. If necessary, remove the crankshaft bearing from the
crankcase.
To remove the crankshaft bearing:
A. Remove the oil filler cap.
B. Heat the relevant crankcase half to 200°C.
C. Use protective gloves and press the bearing out
from the crankcase half.
8. If the crankshaft bearing should remain on the
crankshaft remove it with puller (Refer to pos. 4 "3
Service tools" on page 8)
9. If necessary, remove the following parts:
A. Bark gripper
B. Rubber stop (A). See fig. 5.
18.2 Cleaning and inspection
NOTE! If the bearings are mounted in the
crankcase, be careful to avoid dirt and unwanted
materials getting in.
Clean all parts and scrape of the remains of gasket ma-
terial from the mating surfaces of the crankcase halves.
Do a check of the following:
1. That the big-end bearing does not have any radial
play. Axial play is acceptable.
2. That the big-end bearing does not have any score
marks or is discoloured on the sides. See fig. 7.
Fig. 2
Fig. 4
Fig. 3
Fig. 5
Fig. 4
Fig. 5
Fig. 6
Fig. 6
Fig. 7
Fig. 7
Crankcase and crankshaft
A
A
English - 47