Husqvarna 390XP Workshop Manual page 22

Electrical system
11.1.3 Assembly
To assemble the ignition system:
1. Fit the flywheel on the spindle. Turn it gently until the
key on the flywheel mates with the recess in the
shaft.
2. Fit the flywheel washer and nut (See fig. 5). Tighten
the nut (Refer to "4 Service data" on page 10)
3. Fit the two pawls on the flywheel. See fig. 6.
4. Remove the piston stop.
5. Fit the ignition module (B) without tightening its bolts.
See fig. 8.
6. Turn the flywheel so that its magnet (G) comes
opposite the ignition module. See fig. 7.
7. Insert the feeler gauge (H) (0.3 mm) between the
ignition module and the flywheel magnet. The
clearance only applies to the two lower pegs on the
ignition module. See fig. 7 and 8.
8. Push the ignition module against the flywheel and
tighten the bolts (Refer to "4 Service data" on page
10).
9. Fit the cable guide (D) See fig. 1 and install the
ignition cable. Connect the ignition cable to the spark
plug.
10. Pull out the cable and install the cable clip (F) on the
ignition module. See fig. 1.
11. Fit the remaining parts on the saw.
11.1.4 Cleaning and inspection
Clean and examine all parts carefully. If there are any
cracks or other damage replace the damaged parts with
new ones. Always use original parts.
22 - English
Fig. 5
Fig. 5
Fig. 5
Fig. 5
Fig. 5
Fig. 6
Fig. 6
Fig. 6
Fig. 6
Fig. 6
H
H
H
H
B
B
G
B
B
G
G
G
Fig. 7
Fig. 7
Fig. 7
Fig. 7 Fig. 7
G
B
G
B
G
G
B
B
0.3 mm
Fig. 8
0.3 mm
0.3 mm
0.3 mm
Fig. 8
Fig. 8
Fig. 8
Fig. 8