Troubleshooting - Yamaha TT-R TT250RN Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
To install the rear wheel
1. Install the drive chain onto the
1
rear sprocket, and then insert the
wheel axle from the left-hand
side.
2
NOTE:
8 Make sure that there is enough
3
space between the brake pads
before inserting the brake disc
4
between the pads.
8 Make sure that the drive chain
5
adjusting plates are installed with
the punched sides facing to the
6
outside.
7
2. Install the axle nut.
3. Adjust the drive chain slack.
8
(See page 6-22 for drive chain
slack adjustment procedures.)
9
4. Tighten the axle nut to the speci-
fied torque, and then install the
cotter pin.
EAU01232
w
Always use a new cotter pin for the
axle nut.
Tightening torque:
Axle nut:
105 Nm (10.5 m0kg)
EW000110

Troubleshooting

Although
receive a thorough inspection before
shipment from the factory, trouble
may occur during operation. Any
problem in the fuel, compression, or
ignition systems, for example, can
cause poor starting and loss of
power.
The following troubleshooting chart
represents a quick and easy proce-
dure for checking these vital systems
yourself.
motorcycle require any repair, take it
to a Yamaha dealer, whose skilled
technicians have the necessary tools,
experience, and know-how to service
the motorcycle properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are often
inferior, have a shorter service life
and can lead to expensive repair
bills.
6-37
EAU01008
Yamaha motorcycles
However, should your