Engine Oil And Oil Filter Element - Yamaha TT-R TT250RN Owner's Manual

Tightening torque:
Spark plug:
13 Nm (1.3 m0kg)
NOTE:
If a torque wrench is not available
when installing a spark plug, a good
estimate of the correct torque is
1/4–1/2 turn past finger
However, the spark plug should be
tightened to the specified torque as
soon as possible.
4. Install the spark plug cap.
PERIODIC MAINTENANCE AND MINOR REPAIR
tight.
1. Check window
2. Maximum level mark
3. Minimum level mark
Engine oil and oil filter
element
The engine oil level should be
checked before each ride. In addition,
the oil must be changed and the oil
filter element cleaned at the intervals
specified in the General maintenance
and lubrication chart.
To check the engine oil level
1. Place the motorcycle on a level
surface and hold it in an upright
position.
NOTE:
Make sure that the motorcycle is
1
positioned straight up when checking
the oil level. A slight tilt to the side
2
can result in a false reading.
3
2. Start the engine, warm it up for
3. Wait a few minutes until the oil
EAU03670
NOTE:
The engine oil should be between the
minimum and maximum level marks.
4.
6-8
several minutes, and then turn it
off.
settles, and then check the oil
level through the check window
located at the bottom right side
of the crankcase.
If the engine oil is below the
minimum level mark, add suffi-
cient oil of the recommended
type to raise it to the correct
level.
1
2
3
4
5
6
7
8
9