Yamaha TT-R TT250RN Owner's Manual page 75

PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
1. Speedometer gear unit
4
To install the front wheel
5
1. Install the speedometer gear unit
into the wheel hub so that the
6
projections mesh with the slots.
2. Lift the wheel up between the
fork legs.
7
8
9
1
1
1. Retainer
EAU03555
NOTE:
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
3. Install the wheel axle.
4. Lower the front wheel so that it is
on the ground.
5. Tighten the wheel axle to the
specified torque.
Tightening torque:
Wheel axle:
60 Nm (6.0 m0kg)
1. Wheel axle
a. Gap
6-35
1
6. Tighten the axle holder nuts to
the specified tightening torque.
Tighten the upper nuts first and
then lower ones. When tightened
in this sequence, there should be
a gap formed at the bottom of
the axle holder.
Tightening torque:
Axle holder nuts:
10 Nm (1.0 m0kg)
7. After tightening the holder nuts,
while applying the front brake,
push down on the handlebars sev-
eral times to check if the front fork
compress and rebounds smoothly.
8. Connect the speedometer cable.
a