Troubleshooting - Ricoh Caplio RR30 Operation Manual

Ricoh operation manual digital camera caplio rr30
Hide thumbs Also See for Caplio RR30:
Table of Contents

Advertisement

F. Troubleshooting
Refer to the symptoms and measures listed below before submiting the camera for repairs. If the
problem persists, contact your nearest Ricoh Service Center.
Power Supply
Symptom
The power does not
Batteries are not loaded. Or they are
come on.
exhausted.
The AC Adaptor is not connected
correctly.
The power cuts out
The camera was left unattended and
during use.
not used, so Auto Power-Off shut it
off.
Batteries are running low.
The power does not
Camera malfunction.
go off.
Cannot recharge the
Battery life.
batteries.
Batteries run out
They are being used in extreme high
quickly.
or low temperatures.
Many shots are being taken in dark
places inside, requiring flash.
Shooting
Symptom
Even if I press the
Batteries are not loaded. Or they are
button, the camera
exhausted.
does not shoot.
The power is not on. Or the camera
is not in Shooting Mode.
The shutter button is not pressed all
the way.
The SD Memory Card is not
formatted.
The SD Memory Card does not have
any free space.
End of SD Memory Card life.
The flash is recharging.
Even if I press the
The SD Memory Card is "locked".
button, the camera
The SD Memory Card's contact
does not shoot.
surfaces are dirty.
I cannot check shot
The image confirmation time is too
images.
short.
Cause
Load the batteries correctly. Recharge or use
the AC Adaptor.
Reconnect it properly.
Turn the power back on.
Recharge the batteries, Replace the batteries
with a new set, Or, use the AC Adaptor if
necessary.
Reload batteries.
If using the AC Adaptor, reconnect it.
Replace the batteries with a new set.
Cause
If using alkaline batteries, replace the batteries
with a new set.
If using rechargeable batteries, recharge or
use the AC Adaptor.
Turn the power on and turn the Mode Dial to
Shooting Mode.
Press the shutter button all the way.
Format the card.
Load a new card, or delete unwanted files.
Load a new SD Memory Card.
Wait until the flash lamp stops blinking.
Release the "Lock (write-protection)".
Wipe off with a soft, dry cloth.
Lengthen the image confirmation time.
145
Measure
Measure
Appendix
Page
p.9
p.10
p.10
P.11
p.97
p.9
p.10
p.9
p.10
p.9
Page
p.9
p.11
p.30
p.94
p.82
p.13
p.13
p.44
p.13
p.100

Advertisement

Table of Contents
loading

Table of Contents