Table of Contents
Advertisement
Symptom
Images do not
The power is not on. Or the LCD
appear on the LCD
Monitor is dark.
Monitor.
The video cable is connected.
The screen display status is in
[SYNCHRO-MONITOR MODE].
It is set to [POWER SAVE].
Although it is set to
The lens is dirty.
Auto Focus, it does
The subject is not in the center of the
not focus.
shooting range.
It is a hard-to-focus subject.
The flash does not
The Shooting Mode is set to
fire. Or the flash
(Multi-Shot) or
cannot recharge.
The flash is set to
The White Balance is set to
something other than Auto mode.
Batteries are running low.
Even though the
The distance to the subject is
flash fired, the
greater than 2.5 meters in Telephoto
picture is dark.
or greater than 4.5 meters in Wide-
angle.
The image is too
You are too close to the subject.
bright.
It is over-exposed.
The brightness of the LCD Monitor is
odd.
The image is too
The shot was taken in a dark place
dark.
while set to
It is under-exposed.
The brightness of the LCD Monitor is
odd.
The image lacks
The picture was shot in conditions
natural color.
that are hard for Auto White Balance
to adjust to.
The date, or
The screen display function is set to
recording
No Display.
information does not
appear.
The brightness of
You are using it in a dark place or
the LCD Monitor
when Auto Focus range and
changes during AF.
surrounding brightness are different.
There is a vertical
This is a phenomenon that occurs
smear on the image.
when a bright subject is shot. It is
called the smear phenomenon.
Cause
Turn the power on. Or adjust the brightness of
the LCD Monitor.
Disconnect the video cable.
Press the Display button and switch display.
Set [POWER SAVE] to off.
Wipe clean with a soft, dry cloth.
Shoot with Focus Lock.
Shoot with Focus Lock or Manual Focus.
Switch the Shooting Mode to
Image).
(Movie).
(Flash Off).
Set to Flash Off with the
Set the White Balance to Auto mode.
If using alkaline batteries, replace with a new
set.
If using rechargeable batteries, recharge or
use the AC Adaptor.
Get closer to your subject and shoot.
Set to Flash Off with the
Use exposure compensation. Cancel
Exposure Time.
Adjust the brightness of the LCD Monitor.
Release the Flash Off with the
(Flash Off).
Use exposure compensation. Set to Exposure
Time.
Adjust the brightness of the LCD Monitor.
Add a white object to the composition. Or use
Auto Balance in a setting other than Flash
shooting or Auto Mode.
Press the Display button and switch display.
This is normal.
This is normal.
146
Measure
(Still
button.
button.
button.
Appendix
Page
p.11
p.101
p.80
p.18
p.96
—
p.32
p.32
p.55
p.44
p.44
p.49
p.9
p.10
p.44
p.44
p.47
p.63
p.101
p.44
p.47
p.63
p.101
p.44
p.49
p.18
—
—
Advertisement
Table of Contents
