Setting Originals; Placing Originals - Ricoh Printer/Scanner Operating Instructions Manual

Setting Originals

The following explains the procedure for placing originals on the exposure glass
and in the ARDF, and setting the scan area and orientation according to how you
have set your originals.
To correctly display the top/bottom orientation of the scanned original on a cli-
ent computer, the placement of the original and the settings made on the control
panel and scanner driver must match.

Placing Originals

Place originals in one of the two orientations show in the table below.
Important
❒ Normally, an original is
make orientation easier to understand. Even if the shape of your original is
different to that shown in the table, the combination of original orientation
and the orientation specified on the control panel or scanner driver does not
change.
❖ Specifying original orientation and setting originals
An original to be scanned
Decide the placement method.
Place the original.
(There are two original orien-
tations.)
The original displayed on a
computer
or , but the table below uses a square original to
Exposure glass
Place the Place the
original so original so
that the top that the top
edge touches edge touches
the top left of the rear of
the expo- the exposure
sure glass. glass.
Setting Originals
ARDF
Place the top Place the
edge of the original so
original first. that the top
edge touches
the back of
the ARDF.
2
49