Connectors; Back Panel Connectors; Configuration Settings; Figure 4. Back Panel Connectors - Intel QM77 User Manual

Reference Board Summary
4.1

Connectors

4.1.1

Back Panel Connectors

Figure 4. Back Panel Connectors

4.1.2

Configuration Settings

Caution: Do not move jumpers with the power on. Always turn off the power and unplug the
power cord from the computer before changing jumper settings or damage may occur to
the board.
Table 7. J1D3-Clear/Keep CMOS Setting
Setup
0-1
1-2 (Short)
To restore the BIOS setting:
(1) Turn off the board and unplug the power cord
(2) Short the header on J1D3 with a jumper for a few seconds (that is, connect pin 1
and pin 2), then disconnect the jumper on that header. Remember that this header is
not shorted with a jumper by default.
(3) Turn on the board
Intel® Core™ i5-3610ME Processor (PGA) and Mobile Intel® QM77 Express Chipset Development Kit
November 2012
Document Number: 328076-001
Default
Clear the contents of CMOS and all BIOS settings will restore to factory
default values.
Function
User Guide
17