Controls, Indicators, And Connections; Front Panel; Rear Panel; Control Port - Dynacord IPX5:4 Installation Manual

14 en | Controls, indicators, and connections
6

Controls, indicators, and connections

6.1

Front panel

Figure 6.1: IPX front panel
1.
2.
3.
6.2

Rear panel

Figure 6.2: IPX rear panel
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Audio inputs channels 5, 6, 7, 8 (IPX10:8 only).
11. Control port (GPIO) connector.
12. PRIMARY and SECONDARY OMNEO/Dante network connector (EtherCON/RJ45).
6.3

Control port

The control port features three GPIOs (general purpose in & outputs) and a ready and fault
contact. It is equipped with an 8-pin Euroblock type connector. Three GPIOs can be defined
by the user to change parameters of the amplifier or get parameter indication to external
devices. They are configurable for analog in, digital in or digital out. The other two ports are
potential free relay toggle contacts for READY or FAULT indication.
2018.04 | 01 | F.01U.330.705
OLED display for amplifier status and level information.
Menu navigation buttons, up, down, and enter for display changes and editing.
Amplifier status indications:
POWER LED indicates power on status.
STANDBY LED indicates standby status.
FAULT detect LED indicates a fault message.
OMNEO present LED indicates OMNEO network is present.
2
1
6 7
Power ON switch.
Ground contact.
FAN - Exhaust air vent for amplifier cooling. Do not obstruct!
Audio inputs channels 1, 2, 3, 4.
Status LED, indicating faults.
MAINS IN - AC mains input socket.
Exhaust air vent for PSU. Do not obstruct!
Power amp outputs Euroblock channels 1, 2, 3, 4 - Class 3 wiring.
Power amp outputs Euroblock channels 5, 6, 7, 8 - Class 3 wiring (IPX10:8 only).
1
3
8 9
Installation manual
IPX Series DSP Multichannel Networking Power
2 3
5
4
10 11
Bosch Security Systems, Inc.
Amplifier
12