Table of Contents
Advertisement
Getting Started
BASE UNIT
ANTENNA
120V WALL OUTLET
3. Insert the small plug on the end of the AC ADAPTOR into the POWER-IN connection
jack on the back of the BASE UNIT.
4. Plug the AC ADAPTOR into a 120V AC wall outlet.
5. Insert one plug of the TELEPHONE LINE CORD into the house TELEPHONE
JACK and the other into the telephone line jack on the back of the BASE UNIT.
(If you have an older 4-prong telephone jack, you will need an RJ-11C TELEPHONE
JACK ADAPTOR. This adaptor is available at the same place you purchased your
telephone.)
6. Raise the ANTENNA on the BASE UNIT for the best reception.
7. We recommend not placing this unit next to appliances. Doing so may cause
interference.
8. TONE/PULSE Select Switch:
A. If your home is equipped with a Tone dialing system, set the
TONE/PULSE select switch to the TONE position.
B. If you have a rotary dialing system, set TONE/PULSE select switch to the
PULSE position.
C. If you are unsure which system you have, set the TONE/PULSE select
switch to the TONE position. Press the
get a dial tone, and press any key on the keypad except the zero. If the dial tone
continues, you do not have Tone dialing service. Press the
on the HANDSET to hang up. Set the TONE/PULSE select switch to the PULSE
mode and try again.
BASE UNIT
POWER-IN
SOURCE
TONE/PULSE
SELECT SWITCH
AC ADAPTOR
TELEPHONE LINE CORD
9
TELEPHONE
CONNECTION
JACK
TALK
button on the HANDSET to
TELEPHONE JACK
TALK
button
Advertisement
Table of Contents
