Recharging The Battery Pack - BellSouth MH9003 Owner's Manual Installation And Operating Instructions

Recharging the Battery Pack

Battery Type
Use the following type and size battery pack:
Cordless Telephone Battery Pack
3.6V, 600mAh
U.S. Electronics Inc.
Ni-Cd Battery Pack: model B650
This battery pack is available through:
U.S. Electronics Service Center
105 Madison Avenue
New York, NY 10016
1-800-338-1694
Recharging the Battery Pack
The nickel cadmium (Ni-Cd) battery pack in the HANDSET can be recharged many
times using the built-in charger in the BASE UNIT.
When the BATTERY LOW indicator starts to blink, a "beep" sound will be heard
every 3 seconds. This indicates that the battery pack needs to be recharged.
Charge the battery pack at least once every 90 days of non-use to avoid battery
failure. When the battery pack can no longer be charged, replacement of the battery
pack will be necessary.
The battery used in your telephone may develop a condition known as "MEMORY".
Once subjected to a regular short discharging routine, the battery pack assumes the
discharging pattern it was subjected to. This is known as a "MEMORY" condition
which causes rapid discharging shortening the battery pack charge span. If you
believe your battery pack has developed a memory condition, do not charge the
HANDSET until the BATTERY LOW indicator comes on. When it does come on,
charge the HANDSET fully for 12 hours.
In order to get maximum life from the HANDSET
battery pack, be sure to charge the HANDSET
IMPORTANT
for 12 hours before initial use.
19
Ni-Cd