Stopping Treatment; Using The Mask-Fitting Feature - ResMed Positive Airway Pressure Device VPAP IV User Manual

6
After starting therapy, an introductory treatment screen will display:
S mode
example

Stopping Treatment

To stop treatment at any time, remove your mask and press
has enabled SmartStart/Stop, simply remove your mask and treatment will end.
Note: SmartStart/Stop does not operate if:
• you have a Full Face Mask; or
Leak Alert is enabled.
•

Using the Mask-Fitting feature

and VPAP IV ST
The VPAP IV
properly. The mask-fitting feature delivers air pressure for a three-minute period, prior
to starting treatment, for checking and adjusting your mask fit to minimise leaks.
To use the mask-fitting feature:
1
Fit your mask as described in the mask user instructions.
2
Hold down
the following screen appears:
The LCD displays a mask-fit star rating from zero to five stars. Three to five stars
indicates a good fit or better. Zero to two stars indicates that the mask needs to be
adjusted.
S:RAMP 4.0-10.0
>>>> PS 6.0
LK: 10L/min RR: 15
MV: 10.2 VT: 680
S**TiMn TiMx 2.0
Ti 1.5s 1: 1.6
SpO2: 98%
HR : 60 exit
include a mask-fitting feature to help you fit your mask
for at least three seconds until air pressure delivery starts and
MASK FIT:
*****
excelnt
Mode and pressure display
Leak and breath information
Inspiration information
This screen only displays if ResLink and
an oximeter are connected
Mask-fit star rating
Using the VPAP IV and VPAP IV ST
. If your clinician
7