ResMed VPAP AUTO 25 User Manual page 17

Problem/Possible Cause
Displays error message:
The air tubing is loose or blocked.
Displays error message:
Component failure.
Displays error message:
You have experienced excessively
high leak levels for more than 20
seconds.
The following message is displayed on the LCD after you try to update settings or copy data to
the Data Card:
Data Card is not inserted
correctly.
You may have removed the Data
Card before settings were copied
to the VPAP device.
The following message is displayed on the LCD after you try to update the settings using the
Data Card:
Settings Invalid Remove Card
The identification details on the
Data Card do not match the
details on your device.
The following message is displayed on the LCD after you try to update the settings using the
Data Card:
Settings Error Remove Card
There is a data error on the Data
Card.
The following message is NOT displayed on the LCD after you try to update the settings using
the Data Card:
The settings were not updated.
14
Check tube!! Key if done
Exxxx Call Service
HIGH LEAK!!! Adjust Mask
Card Error Remove Card
Settings Success Remove Card
Solution
Check that the air tubing is connected securely to your mask
and the air outlet. Press the Start/Stop key to restart the
device. If this does not clear the message, disconnect the
power cord and then reconnect it to restart the device.
(where
xxxx
Record error number and contact your ResMed service center.
Check that your air tubing is connected properly.
Adjust headgear.
Ensure that the Data Card is inserted with the arrow facing up
as far as it can go.
Reinsert the Data Card and wait for the Settings Success
Remove Card or Copy Complete Remove Card message
to appear on the LCD.
Contact your clinician/service provider immediately.
Contact your clinician/service provider immediately.
Contact your clinician/service provider immediately.
defines an error)