Table of Contents
Advertisement
AutoOff
What is AutoOff? When enabled, the AutoOff safety feature turns off the power to the handpiece after a pre-
selected time (between 10- 90 minutes) from the system entering Temperature Setback. When the system has
entered Temperature Setback, a timer within the system circuitry will start running.
If any key is pressed during the selected time out period, the AutoOff and Setback timers are reset. The system
will return to normal operation. At the end of the time out period, the system will enter Auto Off. Power is turned
off to the heater and the Digital Display will show a flashing "OFF". Exiting Auto Off: Auto Off can be exited;
returning to normal operation by pressing and releasing a Key (any of the 3 keys), or by turning the Power
Switch OFF ("0") and then back ON ("1").
8. The Digital Display now shows the stored Auto Off time as "AOx" (x=0 thru 9). Time is shown as tens of
minutes (e.g., "AO8" equals 80 minutes). A display of "AO0" indicates that Auto Off
is disabled. Choose one of the following:
Press and release the Program Key ( ) to keep the currently stored Auto
•
Off time.
Adjust the Auto Off value using the keypad.
•
Press and release the Program Key ( ) to proceed to the next step.
•
Instant SetBack Timer
9. The Digital Display will alternate between "ISb" and a value between 015 and 240
representing seconds. This indicates how long of a delay before the system goes
into SetBack mode when the handpiece is placed into the Instant SetBack Tool
Stand, if one is attached.
Press and release the Program Key ( ) to keep the currently stored Instant
•
SetBack time.
Adjust the stored Instant Setback Timer value using keypad. (
•
Press and release the Program Key ( ) to proceed to the next step.
•
Temperature Presets 1-3
10. The Digital Display will now alternate between "PSx" (x= 1 thru 3) and a
temperature. These three options control the three Temperature Presets that can
be used during normal operation by simply pressing the Program Key ( ) to
activate them.
Press and release the Program Key ( ) to keep the currently stored
•
Temperature Preset for Preset 1 or;
Adjust temperature value using the keypad. (
•
Press and release the Program Key ( ) proceed to the next step or to the
•
next feature after "PS3".
Improving Tip Life Using Temperature Preset: Solder alloys, especially lead-free alloys, are
destructive to the protective iron plating on tips and much more aggressively corrosive at any temperature over
solder melt. In general, the higher the temperature, the more destructive to the iron plating. To significantly
improve tip life, program 350° F or 177°C into the PS1 position. When the ADS200 is not in use, press the
Program Key to initiate a "Manual Temperature SetBack" and when ready to use the station again push the
Program Key twice to re-establish the operating temperature that is in the PS2 position.
©2018 PACE Inc., Vass, North Carolina, All Rights Reserved
)
)
Page 8
Hide quick links:
Advertisement
Table of Contents
