Furuno SC-33 Operator's Manual page 16

1. MOUNTING
Note: Fasten the double nuts as Note: Fasten the double nuts as
shown in the figure to the shown in the figure to the
right. Use spanners with a right. Use spanners with a
length of approx. 200 mm. length of approx. 200 mm.
4. Coat the exposed parts of the nuts, bolts and washers with the Adhesive TB5211 (included)
to prevent corrosion.
Mounting platform
5. Connect the antenna pig tale connector to the NMEA2000 bus or a cable from the optional
unit, then waterproof the connection. See chapter 2 for the wiring and the waterproofing.
6. Remove the double-sided tape from the optional bird-repellent fixtures, then attach to the
antenna cover. Coat around the bird-repellent fixtures with the Adhesive TB5211 (included).
7. Fix the satellite compass cable to the pipe at suitable intervals with the cable ties (local sup-
ply).
Note: Create a loop in the cable close to the satellite compass and tie the loop with a cable
tie for maintenance work, as shown in the below figure.
Create a loop of more than 15 cm in
diameter (approx. twice the length of a
pigtail connector) so that the loop does
not put stress on the pigtail connector.
Nut2: Fix in place
Antenna base Antenna base
Flat washer
Spring washer
Bolt
Coat with adhesive.
Hex nuts
more
than
15 cm
9
Nut1: Fasten Nut1: Fasten