3Com 5500G Configuration And Command Reference Manual page 28

28 Chapter 3: Configuring an Application Control System Exchange Interface
Controlling ACSEI
Client
c
[ * ] specifies that the Linux system automatically starts up ACSEI
■
client when started up.
[ ] specifies that the Linux system does not start up ACSEI client when
■
started up.
5 Check your choice, use the Tab key to move the cursor to OK, press
Enter. You return to the previous view.
6 Select Quit to exit the Setup interface.
Follow these steps to control ACSEI client:
To...
Switch to the OSN|M's
Linux system from the
switch's CLI
Start up the ACSEI client
Load the ACSEI client
configuration file
Restart the ACSEI client
Restart the ACSEI client
conditionally
Stop the ACSEI client
CAUTION:
Conditional restart means that if the ACSEI client process is running,
■
the command stops the process and then restarts it, and if the ACSEI
client process is not running, the command does not restart the
process.
Do not stop and restart the ACSEI client process repeatedly within five
■
seconds; otherwise, other applications may not be aware of the ACSEI
client change.
Use the command...
osm connect unit unit-id
service acseid start
service acseid reload
service acseid restart
service acseid
condrestart
service acseid stop
Remarks
Required
Available in user view
After the operation, the
operating interface is
switched to the Linux
system interface where
you can execute the
following commands.
Optional
By default, the ACSEI
client is started up.
Optional
Optional
Optional
Optional