Ford Escape 2010 Workshop Manual page 58

Item Part Number
1 50202
2 41302
3 50222
4 50222
5 50222
6 50244
7 03408
WARNING: Collision damage repair must conform to the instructions contained in this workshop
manual. Replacement components must be new, genuine Ford Motor Company parts. Recycled, salvaged,
aftermarket or reconditioned parts (including body parts, wheels or safety restraint components) are not
authorized by Ford.
Departure from the instructions provided in this manual, including alternate repair methods or the use of
substitute components, risks compromising crash safety. Failure to follow these instructions may adversely
affect structural integrity and crash safety performance, which could result in serious personal injury to
vehicle occupants in a crash.
WARNING: Invisible ultraviolet and infrared rays emitted in welding can injure unprotected eyes and
skin. Always use protection such as a welder's helmet with dark-colored filter lenses of the correct density.
Electric welding will produce intense radiation, therefore, filter plate lenses of the deepest shade providing
adequate visibility are recommended. It is strongly recommended that persons working in the weld area wear
flash safety goggles. Also wear protective clothing. Failure to follow these instructions may result in serious
personal injury.
WARNING: Always wear protective equipment including eye protection with side shields, and a dust
mask when sanding or grinding. Failure to follow these instructions may result in serious personal injury.
NOTICE: Be sure to adequately protect all glass, exterior finish and interior trim to avoid damage during the
repair procedure.
1. WARNING: Depower the high-voltage traction battery (HVTB) before carrying out any removal
or installation procedures affecting the high-voltage battery system. Failure to follow this
instruction may result in serious personal injury or death.
Remove the windshield and quarter panel glass. For additional information, refer to
Description
Roof panel — mild steel
Back panel reinforcement — mild steel
Roof panel reinforcement — mild steel
Roof panel reinforcement — mild steel
Roof panel reinforcement — mild steel
Roof panel reinforcement — mild steel
Windshield header — mild steel
Section 501-11 .