Table of Contents
Advertisement
Registering the camera
This procedure is not required for devices
that were included as part of a bundle.
Before you can use the camera, it must be
registered to the hub.
If the camera is not registered to a hub, the
camera's LED indicator blinks slowly in amber.
You can register each device by using the
registration buttons or the [Home Network]
app.
Note:
R Before registering the camera, make sure
the AC adaptors of the hub and camera are
connected and each device is powered.
Using registration buttons
1
Hub:
Press and hold M
LED indicator blinks slowly in green.
2
Camera:
Using an object with a thin tip, press and
hold M
N until the LED indicator blinks
slowly in green (page 18).
R When registration is complete, the hub
sounds one long beep.
Note:
R To cancel without registering the camera,
press M
N on the hub and on the camera
again.
R If registration fails, the hub sounds several
short beeps.
Helpline Tel. No.: U.K. 0330 3331112 Ireland 01 4475228
HNC600E_(en_en)_1227_ver.102.pdf
Using the app
When you register the camera by using the
[Home Network] app, you can assign a name
to your devices and group them by location.
For more information, refer to the User's
Guide (page 29).
Confirming the installation
area
Before deciding where to install the camera,
carefully read the chapter "Installation
Location", beginning on page 11, to confirm
the installation location and direction.
CAMERAN until the
19
Setup
19
2016/12/27
23:35:23
Advertisement
Table of Contents
