Suspended Ceiling Installation-Drop Ceiling Tiles - 3Com AP3850 Quick Installation Manual

Suspended Ceiling
Installation—Drop
Ceiling Tiles
T-bar
T-bar clamp halves
23.9-mm (15/16-inch) or 14.2-mm (9/16-inch) T-bar
(The clamps are different widths but the assembly is the same.)
5 Attach the AP3850 to the mounting bracket.
Lock
T-bar
This procedure applies to T-bars that are 23.9 mm (15/16 inches),
14.2-mm (9/16-inches), or 15.9-mm (5/8-inches) wide. You also can
use this procedure for flush ceilings with 14.2-mm (9/16-inch) or
15.9-mm (5/8-inch) T-bars.
Mobility
point
1 Use the mounting template to cut a hole for the Cat 5 cable.
2 Install the T-bar clamp that fits the T-bar.
Slide together
3 Remove the mounting bracket from the AP3850.
4 Attach the mounting bracket to the T-bar clamp.
5 Insert the Cat 5 cable through the port connector opening in the mounting bracket,
then plug the cable into the AP3850.
Mounting T-bar clamps
template (use set that fits T-bar)
T-bar
T-bar clamp halves
Mounting
bracket
Slide together
15.9-mm (5/8-inch) T-bar