Connecting The Modem - Paradyne FrameSaver SLV 9626 Installation Manual

Connecting the Modem

Procedure
1. Insert the 6-pin connector on the modem cable into the MDM interface.
2. Insert the other end of the cable into the modem service RJ11C jack.
POWER
3. Verify modem operation.
If Port Use is set to Terminal (dial-in access):
— Dial the modem's phone number using a remote asynchronous terminal or PC.
— Verify that the Main Menu appears.
If Port Use is set to Net Link (SNMP, Telnet, FTP, and trap dial-out):
— Dial the modem's phone number using a PC running PPP or SLIP link protocol.
— From the PC, run an IP Ping test to the modem interface.
If your results using either method are unsuccessful, make sure both ends of the
modem cable are properly seated and secured. Then, verify that the modem was
configured correctly (see
the status information in the FrameSaver SLV Operations Guide .
Proceed to Connecting to ISDN
capability.
COM
Setting Up the Modem
on page 26 if the FrameSaver unit has ISDN backup
NET MDM DBM
on page 16). Otherwise, refer to
25
RJ11C
Jack
99-16482