About The Installation Procedures; Full Installation And Setup - Paradyne FrameSaver SLV 9626 Installation Manual

About the Installation Procedures

There are two methods for installing and setting up the FrameSaver unit.
One person can install and set up the unit. If this is the case, see
and Setup .
An installer can physically install and set up access to the unit, and the network
operation center (NOC) can complete the setup. If this is the case, see
Installation for Service Providers
Certain procedures are common to both the full installation and minimal methods. These
procedures (starting with
are referenced in the full and minimal installation instructions. Refer to them, as needed.

Full Installation and Setup

An Easy Install screen is provided to simplify installation and setup. The Easy Install
feature can be used for the first part of the installation when one person is installing and
setting up the unit from beginning to end.
Easy Install Screen Example
main/easy_install
Device Name: Node A
Service Type
Node IP Address:
Node Subnet Mask:
TS Access:
Create a Dedicated Network Management Link
Network1 DDS Line Rate (Kbps):
Network Initiated DCLB:
DSU Latching Loopback (64CC):
Require DSU Latching Loopback Preamble
---------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu
Save
on page 13.
Setting Up Local Management at the Central Site
EASY INSTALL
DLCI
10
Full Installation
12/26/2002 23:32
Frame Relay
000.000.000.000
000.000.000.000
980
Initialize From Network
V.54 & ANSI
Enable
Enable
MainMenu
Minimal
on page 15)
9626
Clear
Clear
Exit