Fuel System Check - Williams Minijet 280 Owner's Handbook Manual

Hide thumbs Also See for Minijet 280:
Table of Contents

Advertisement

Engine Bay Arrangement
3
2
1
1
Engine fuses
5
2
Boat fuse inline 30 amp
6
3
Battery
7
4
Battery isolator relay
8

Fuel System Check

WARNING.
Pressurised fuel system. Inspect system for leaks at scheduled service
intervals. All elements of the fuel system function under pressure (4 bar). The system
remains pressurised after engine is switched off. Extreme care must be taken when removing
quick connectors during filter change. Wear eye protection. No naked flames.
12
williamsjettenders.com
10
6
4
5
9
Coolant expansion tank
9
Engine oil dipstick and filler
Engine air filter
10 Fuel filler
Power limit switch
Towing valve
After Use: Flushing Procedure
To prolong engine life it is very important to flush engine of salt water after use and prior to
storage. Failure to carry out flushing will significantly reduce the life of engine components and
may invalidate the warranty.
In addition it is advised to thoroughly wash with fresh water around the jet pump area to remove all
salt deposits after use.
CAUTION.
flooding exists if water remains on after engine is switched off. NEVER run engine
longer than 2 minutes. Drive line seal has no cooling when boat is out of water.
1 Clean jet pump by spraying fresh water into its inlet and outlet.
2 Connect a fresh water hose fitted with the female connector to the flushing attachment
coupling fitted to the tender.
3 Start engine and immediately open the water tap.
4 Run the engine for about 20 seconds, between 4000 and 5000 rpm.
5 Ensure water flows out of jet pump whilst flushing. Otherwise, contact your authorized
Williams Dealer.
6 Turn off tap.
7
7 Allow the engine to run on for no longer than 10 seconds to allow water to exit from the
cooling system, then turn off the engine. Remove hose connector from flushing attachment.
8 Check bilge of boat and dry any residual water. Remove footwell drain plugs.
8
1
4
Engine MUST be running before water is connected. Risk of engine
2
3
4
1
2
1 Pump assembly anode
2 Steering cable
3 Reverse cable
4 Footwell drain outlets
1 Flushing attachment
2 Bilge drain plug
13
williamsjettenders.com

Advertisement

Table of Contents
loading

Table of Contents