Cisco 300 Series Administration Manual page 346

Managed switch

Hide thumbs Also See for 300 Series:

Table of Contents

Link Local—The IPv6 address uniquely identifies hosts on a single

network link. A link local address has a prefix of FE80, is not routable, and

can be used for communication only on the local network. Only one link

local address is supported. If a link local address exists on the interface,

this entry replaces the address in the configuration.

Global—The IPv6 address is a global Unicast IPV6 type that is visible and

reachable from other networks.

Link Local Interface—If the IPv6 address type is Link Local, select the

interface through which it is received.

Host Name—Enter a user-defined host name or fully-qualified name. Host

names are restricted to the ASCII letters A through Z (case-insensitive), the

digits 0 through 9, the underscore and the hyphen. A period (.) is used to

separate labels.

IP Address(es)—Enter a single address or up to eight associated IP

addresses (IPv4 or IPv6).

You can select the Clear Table option to clear some or all of the entries in the Host

Mapping Table.

Static Only—Deletes the static hosts.

Dynamic Only—Deletes the dynamic hosts.

All Dynamic & Static—Deletes the static and dynamic hosts.

Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)

IP Configuration