Cisco 300 Series Administration Manual page 345

IP Configuration
Domain Name
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)
To add a host name and its IP address:
Click IP Configuration > Domain Name System > Host Mapping.
If required, select the Clear Table option to clear some or all of the entries in the
Host Mapping Table.
• Static Only—Deletes the static hosts.
• Dynamic Only—Deletes the dynamic hosts.
• All Dynamic & Static—Deletes the static and dynamic hosts.
The Host Mapping Table displays the following fields:
• Host Name—User-defined host name or fully-qualified name.
• IP Address—The host IP address.
• IP Version—IP version of the host IP address.
• Type—Is this a Dynamic or Static entry to the cache.
• Status— Displays the results of attempts to access the host
OK
- —Attempt succeeded.
Negative Cache
-
No Response
-
future.
• TTL— If this is a dynamic entry, how long will it remain in the cache.
• Remaining TTL— If this is a dynamic entry, how much longer will it remain in
the cache.
To add a host mapping, click Add.
Enter the parameters.
• IP Version—Select Version 6 for IPv6 or Version 4 for IPv4.
• IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The
options are:
—Attempt failed, do not try again.
—There was no response, but system can try again in
17
319