Test Mode - Roland RS-5 Service Notes

RS-5

TEST MODE

Equipment needed
• Headphones
• Monitor speakers (MA-12 etc.), 2
• Audio cables, 2
• MIDI cable, 1
• Expression pedal
• Hold pedal
Cautions on starting the test
• User data may be erased when entering the test mode.
Be sure to back up the data.(See Save and Load of User Data)
• Some of the test items output check sounds.
Connect headphones or monitor speakers beforehand.
Testing items
The RS-5 includes the following tests.
For details on each tests, refer to each item.
0 : Test Mode Title
1 : Memory Test
2 : MIDI Test
3 : Switch & LED Test
4 : LCD & 7-seg LED Test
5 : A/D Test 1 (Bender, Modulation)
6 : A/D Test 2 (Control Knob)
7 : A/D Test 3 (Hold Pedal, Expression Pedal)
8 : Keyboard Test
9 : Sound Test
10 : Factory Reset/User Memory Test
Button operation
Entering the test mode
Turning on the power while pressing the [PERFORM/TONE],
[USER/PRESET] and [1/PIANO] buttons brings up the title
screen of the test mode.
Movement of Each Testing Item
• Pressing [ENTER] on the title screen of the test mode starts the
test mode.
• Testing items 1~3, 5~7 when no problems occur, will
automatically proceed to the next test item.
• Even when the test is not finished, pressing [PART<] or
[PART>] while pressing [SHIFT] proceeds to the next or the
previous testing item, respectively.
Jumping to Each Test
Pressing the ten key while pressing [SHIFT] enables direct
selection of the corresponding testing item.
0 : [SHIFT]+[EXIT] Test Mode Title
1 : [SHIFT]+[1] Memory Test
2 : [SHIFT]+[2] MIDI Test
3 : [SHIFT]+[3] Switch & LED Test
4 : [SHIFT]+[4] LCD & 7seg Test
5 : [SHIFT]+[5] A/D Test1 (Bender & Modulation)
6 : [SHIFT]+[6] A/D Test2 (Control Knob)
7 : [SHIFT]+[7] A/D Test3 (Hold Pedal, Expression Pedal)
8 : [SHIFT]+[8] Keyboard Test
9 : [SHIFT]+[9] Sound Test
10 : [SHIFT]+[0] Factory Reset/User Memory Test
Ending the test mode
Turn off the power.
* Do not turn off the power while factory resetting.
Turn off the power after terminating factory resetting.
Details on Testing Items
0 : Test Mode Title
• Check the CPU and Program ROM version.
Upgrade when the version is insufficient.
Refer to [Upgrading] for updating.
• Check that the LCD backlight lights evenly.
Check the following parts if it does not .
MAIN BOARD L24,CN9
PANEL A BOARD R55~58, LED27~34, CN1
• Pressing [ENTER] starts the test mode.
Jan. 2001
11