Table of Contents
Advertisement
2.
Click Add to add IP filter rules.
A maximum of 32 rules (including defaults) can be assigned to the table.
3.
Assign each parameter referring to the descriptions below.
Parameter & Description
Action
Specifies whether the IP packet is blocked or
allowed to pass.
Source
IP Address
Specifies the source IP address.
Mask
Specifies the source subnet mask
address.
TCP/UDP Port
Specifies the range of the source
port number to apply the filter rule.
Destination
IP Address
Specifies the destination IP
address.
Mask
Specifies the destination subnet
mask address.
TCP/UDP Port
Specifies the range of the
destination port number to apply
the filter rule.
Document Version 2008-10
Block
No default
0 (0.0.0.0)
No default
*2
No default
0 (0.0.0.0)
No default
*2
Default
Value Range
Block, Allow
Available source IP
addresses
0, 8–32
*1
1–65535
*3
Available destination IP
addresses
Available destination subnet
mask addresses
1–65535
*3
3.5.3 IP Filter
*1
*1
*1
Installation Manual
55
Advertisement
Table of Contents
