Table of Contents
Advertisement
2.1.2 Installing the SIP-GW4 Card in the PBX
Install the SIP-GW4 card in slot 05, 06, or 07 of the PBX.
1.
Before installing the card, cut and remove the dummy cover plate for the appropriate slot from the main
unit.
CAUTION
For safety reasons, smooth the cut edges after removing the dummy cover plate.
2.
Position the card in the open slot, making sure that the tabs on both sides of the card fit into place. Then,
holding the card firmly in place, lower the rear end so that the hole of the card fits over the extension bolt.
Extension Bolt
Document Version 2008-10
Dummy Cover Plate
2
2.1.2 Installing the SIP-GW4 Card in the PBX
1
Installation Manual
15
Advertisement
Table of Contents
