Table of Contents
Advertisement
3.3.2 LAN Interface
1.
Click 1.1.2 LAN Interface in the operation menu.
2.
Assign each parameter referring to the descriptions below.
Parameter & Description
IP Address
Specifies the IP address of the card.
Subnet Mask
Specifies the subnet mask address of the card.
Note
•
Do not assign an IP address and a subnet mask address from the same network as the WAN port,
for example:
LAN port: IP address 192.168.0.1, Subnet mask 24 (255.255.255.0)
WAN port: IP address 192.168.0.2, Subnet mask 24 (255.255.255.0)
If you do so, disconnect the cables from the LAN and WAN ports and reboot the SIP-GW4 card.
Then, connect the cable only to the LAN port, and reassign the IP address and subnet mask
address for the LAN port.
•
If you change the IP address or subnet mask address of the card here, the settings of IP
Masquerade (NAPT) in 3.5.4 NAT Settings may need to be changed as well. Refer to "3.5.4 NAT
Settings".
3.
Click Set.
A confirmation screen is displayed.
Document Version 2008-10
Default
192.168.0.1
Available IP addresses for the
card
24 (255.255.255.0)
8–30
3.3.2 LAN Interface
Value Range
Installation Manual
33
Advertisement
Table of Contents
