Installation - Daikin FH15CBV1L Technical Manual

Installation Guideline
Safety Precautions
•
Installation and maintenance should be performed by qualified persons who are familiar with local code and regulation,
and experienced with this type of appliance.
•
All field wiring must be installed in accordance with the national wiring regulation.
•
Ensure that the rated voltage of the unit corresponds to that of the name plate before commencing wiring work according
to the wiring diagram.
•
The unit must be GROUNDED to prevent possible hazard due to insulation failure.
•
All electrical wiring must not touch the refrigerant piping, or any moving parts of the fan motors.
•
Confirm that the unit has been switched OFF before installing or servicing the unit.
•
Disconnect from the main power supply before servicing the air conditioner unit.
•
DO NOT pull out the power cord when the power is ON. This may cause serious electrical shocks which may result in
fire hazards.
•
Keep the indoor and outdoor units, power cable and transmission wiring, at least 1m from TVs and radios, to prevent
distorted pictures and static. {Depending on the type and source of the electrical waves, static may be heard even when
more than 1m away}.
Please take note of the following important points when installing.
•
Do not install the unit where leakage of flammable gas may occur.
If gas leaks and accumulates around the unit, it may cause fire ignition.
•
Ensure that the drainage piping is connected properly.
If the drainage piping is not connected properly, it may cause water leakage which will dampen the furniture.
•
Do not overcharge the unit.
This unit is factory pre-charged.
Overcharge will cause over-current or damage to the compressor.
•
Ensure that the unit's panel is closed after service or installation.
Unsecured panels will cause the unit to operate noisily.
•
Sharp edges and coil surfaces are potential locations which may cause injury hazards.
Avoid from being in contact with these places.
•
Before turning off the power supply, set the remote controller's ON/OFF switch to the "OFF" position to prevent
the nuisance tripping of the unit. If this is not done, the unit's fans will start turning automatically when power
resumes, posing a hazard to service personnel or the user.
•
Do not install the units at or near doorway.
•
Do not operate any heating apparatus too close to the air conditioner unit or use in room where mineral oil, oil vapour
or oil steam exist, this may cause plastic part to melt or deform as a result of excessive heat or chemical reaction.
•
When the unit is used in kitchen, keep flour away from going into suction of the unit.
•
This unit is not suitable for factory used where cutting oil mist or iron powder exist or voltage fluctuates greatly.
•
Do not install the units at area like hot spring or oil refinery plant where sulphide gas exists.
•
Ensure the color of wires of the outdoor unit and the terminal markings are same to the indoors respectively.
•
IMPORTANT : DO NOT INSTALL OR USE THE AIR CONDITIONER UNIT IN A LAUNDRY ROOM.
•
Don't use joined and twisted wires for incoming power supply.
•
The equipment is not intended for use in a potentially explosive atmosphere.
5. Installations
WARNING
CAUTION
42