Hobart Jet-Ex 5D Operation And Maintenance Manual page 78

OM-2094 / Operation and Maintenance Manual
Jet-Ex 5D / Series 500285/ Generator Set
(2) "HOBART PART NUMBER" Column
ALL part numbers appearing in this column are Hobart numbers. In all instances where the part
is a purchased item, the vendor's identifying five-digit code and his part number will appear in
the "Nomenclature" column. Parts manufactured by Hobart reflect no vendor code or part
number in the "NOMENCLATURE" column.
(3) "NOMENCLATURE" Column
The item identifying name appears in this column. The indenture method is used to indicate item
relationship. Thus, components, of an assembly are listed directly below the assembly and
indented one space. Vendor codes and part numbers for purchased parts are shown in this
column. Hobart modification to vendor items is also noted in this column.
(4) "EFF" (Effective) Column
This column is used to indicate the different models that use the part on that line. There are
some parts may be used on only one, or a variety of models. A code letter "A", "B", etc., is
placed in EFF column to indicate these parts. It can be cross referenced to the particular model it
is used on. If a letter is not placed in that column, then all models use that part.
Parts coded "A" are useable on part number 500285-001 only.
Parts coded "B" are useable on part number 500285-002 only.
(5) "UNITS PER ASSEMBLY" Column
This column indicates the quantity of parts required for an assembly or subassembly in which the
part appears. This column does not necessarily reflect the total used in the complete end item.
Chapter 4-1
Page 2
November 1, 2000