Stihl BT 120 C Instruction Manual page 25

English / USA
6
: Ease the cap (5) out of the starter
grip.
: Remove remaining rope from the
rotor and grip.
:
Tie a simple overhand knot in the
new rope – see "Specifications" –
and then thread it through the top of
the grip and the rope bush (6).
:
Refit the cap in the grip.
24
5
: Thread the rope through the rotor
and secure it with a simple
overhand knot.
:
Coat rope rotor bearing bore with
non-resinous oil – see "Special
Accessories".
:
Slip rotor over starter post – turn it
back and forth to engage anchor
loop of rewind spring.
:
Refit the pawl (4).
:
Fit the washer (3).
: Install spring clip (2) on starter post
and engage it on the pawl's peg –
the spring clip must point clockwise.
2
3
4
Tensioning the Rewind Spring
:
:
:
7
Make a loop in the unwound
starter rope and use it to turn
the rope rotor six full revolutions
counterclockwise.
Hold the rotor steady – pull out and
straighten the twisted rope.
Release the rope rotor.
BT 120 C
7