Stihl BT 120 C Instruction Manual page 10

Table of Contents

Advertisement

Available languages

Available languages

!
Warning!
Operate and start your earth auger only
outdoors in a well ventilated area.
Operate the earth auger under good
visibility and daylight conditions only.
Work carefully. Always hold the earth
auger firmly with both hands. Wrap your
fingers tightly around the handles,
keeping the handles cradled between
your thumb and fingers. Keep your
hands in this position to have your earth
auger under control at all times. Make
sure your earth auger handles and grip
are in good condition and free of
moisture, pitch, oil or grease.
DANGER!
Contact with electrical
cables or wires can cause
serious injury or death as
a result of electrical
shock. This unit is not
insulated.
BT 120 C
!
Warning!
To reduce the risk of electrocution and
damage to property, always be alert for
underground pipes and cables and for
overhead wires. Before drilling, obtain
the necessary plans and permits.
Contact your local utility company or
your locator service, such as "Miss
Utility" or "One Call", for information as
to cable and pipe locations. Where
necessary, confirm actual location by
use of devices such as cable detectors
and/or by carefully dug trenches. Stay
clear of overhead electrical wires when
backing the drilling tool out of the hole. If
any portion of the machine strikes a
wire, it will cause electrical shock or
death.
!
Warning!
To reduce the risk of falling, be careful
when carrying or operating the machine
in slippery conditions when the ground is
wet, icy or snow covered. Special care
must also be taken on embankments
and slopes.
English / USA
Operating Instructions
!
Warning!
To reduce the risk of injury, never touch
a rotating drilling tool or drilling spindle
with your hand or any part of your body.
It continues to rotate for a short period
after the throttle lever is released.
Always shut off the engine before putting
the machine down or transporting it over
a long distance.
When taking the drilling tool out of the
hole, lift the machine vertically so that
the tool comes out straight without
canting. Cover and clearly mark
boreholes, to prevent anyone from
stepping in a hole.
9

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents