Daikin BRC7E61W Operation Manuals page 4

Remote Controller (Wireless Type)
See Fig. 1, 2
10
11
12
13
14
15
16
17
18
19
20
21
22
23
50
DISPLAY " " (SIGNAL TRANSMISSION)
1
This lights up when a signal is being transmitted.
DISPLAY " " " " "
2
This display shows the current OPERATION MODE. For cooling only type, "
and " " (Heating) are not installed.
H M L
DISPLAY " " (SET TEMPERATU RE)
3
C
This display shows the set temperature.
DISPLAY "
hr. hr.
4
This display shows PROGRAMMED TIME of the system start or stop.
DISPLAY " " (AIR FLOW FLAP)
5
Refer to page 56.
DISPLAY " " " " "
6
The display shows the set fan speed.
DISPLAY "
TEST
7
When the INSPECTION/TEST OPERATION BUTTON is pressed, the display shows the
system mode is in.
ON/OFF BU TTON
8
Press the button and the system will start. Press the button again and the system will stop.
FAN SPEED CONTROL BU TTON
9
Press this button to select the fan speed, HH, H, L of your choice.
TEMPERATU RE SETTING BU TTON
Use this button for SETTING TEMPERATURE
(Operates with the front cover of the remote controller closed.)
PROGRAMMING TIMER BU TTON
Use this button for programming "START and/or STOP" time.
(Operates with the front cover of the remote controller opened.)
TIMER MODE START/STOP BU TTON
Refer to page 57.
TIMER RESERVE/CANCEL BU TTON
Refer to page 57.
AIR FLOW DIRECTION ADJ U ST BU TTON
Refer to page 56.
OPERATION MODE SELECTOR BU TTON
Press this button to select OPERATION MODE.
FILTER SIGN RESET BU TTON
Refer to the section of MAINTENANCE in the operation manual attached to the indoor unit.
INSPECTION/TEST OPERATION BU TTON
This button is used only by q ualified service persons for maintenance purposes.
EMERGENCY OPERATION SWITCH
This switch is readily used if the remote controller does not work .
RECEIVER
This receives the signals from the remote controller.
OPERATING INDICATOR LAMP (Red)
This lamp stays lit while the air conditioner runs. It flashes when the unit is in trouble.
TIMER INDICATOR LAMP (Green)
This lamp stays lit while the timer is set.
AIR FILTER CLEANING TIME INDICATOR LAMP (Red)
Lights up when it is time to clean the air filter.
DEFROST LAMP (Orange)
Lights up when the defrosting operation has started.
(For cooling only type this lamp does not turn on.)
" " " " " (OPERATION MODE)
" (PROGRAMMED TIME)
" (FAN SPEED)
" (INSPECTION/ TEST OPERATION)
OH08-1
" (Auto)
Control Systems