The installation position of this kit is TO THE EQUIPMENT. BE SURE ONLY TO USE 1 position of the decoration panel. ACCESSORIES MADE BY DAIKIN WHICH ARE Therefore, confirm that its position is set so SPECIFICALLY DESIGNED FOR USE WITH...
Determination of address and MAIN/SUB EMOTE CONTROLLER INSTALLATION remote controller Installing wireless remote controller If setting multiple wireless remote controllers to operate in one room, perform address setting for the Do not throw the remote controller or impose large receiver and the wireless remote controller. shocks.
Setting the address of wireless remote controller Stick the unit number label (See figure 3) Stick the unit number label on the air outlet of the decoration panel and on the back of the wireless remote Mode controller. Address (is factory set to “ ”) Multiple setting Setting from the remote controller...
Refer to figure 9. Connect the harness from the (See figure 4) transmitter board to the connector X24 on the indoor MODE NO. unit PC board. FIELD SET MODE Be sure to pass only the harness FIRST CODE NO. connecting to the indoor unit PC board SECOND CODE NO.
EST OPERATION OTES Perform the test operation according to the instructions in the installation manual delivered with the indoor unit. After refrigerant piping, drain piping, and electric wiring, operate as follows to protect the unit: 1 Open the gas side stop valve. 2 Open the liquid side stop valve.